![background image](http://html1.mh-extra.com/html/sick/dusthunter-sp100/dusthunter-sp100_operating-instructions-manual_1264547007.webp)
7
8012426/YWL2/3-0/2016-08| SICK
O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER SP100
Subject to change without notice
IMPORTANT INFORMATION
1
1
Important Information
1.1
Main hazards
1.1.1
Hazard through hot and/or aggressive gases and high pressure
The optical subassemblies are fitted directly on the gas-carrying duct. On equipment with
low hazard potential (no danger to health, ambient pressure, low temperatures), the instal-
lation or removal can be performed while the equipment is in operation providing the valid
regulations and equipment safety notices are observed and suitable protective measures
are taken.
1.1.2
Hazards through electrical equipment
1.1.3
Hazards through laser beam
1.2
Symbols and document conventions
1.2.1
Warning Symbols
1.2.2
Warning levels and signal words
DANGER
Risk or hazardous situation which
will
result in severe personal injury or death.
WARNING
Risk or hazardous situation which
could
result in severe personal injury or death.
CAUTION
Hazard or unsafe practice which
could
result in less severe or minor injuries.
NOTICE
Hazard which
could
result in property damage.
WARNING: Danger from exhaust gas
▸
On equipment with gases detrimental to health, high pressure or high tem-
peratures, the sender/receiver unit component fitted on the duct may only
be installed/removed when the equipment is at a standstill.
WARNING: Danger through power voltage
The DUSTHUNTER SP100 measuring system is classified as electrical.
▸
Disconnect power supply lines before working on power connections or
parts carrying power voltage.
▸
Refit any contact protection removed before switching the power voltage
back on again.
WARNING: Hazards through laser beam
▸
Never look directly into the beam path
▸
Do not point the laser beam at persons
▸
Pay attention to laser beam reflections.
Symbol
Significance
Hazard (general)
Hazard by voltage