![background image](http://html1.mh-extra.com/html/sick/dusthunter-sp100/dusthunter-sp100_operating-instructions-manual_1264547058.webp)
58
8012426/YWL2/3-0/2016-08| SICK
O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER SP100
Subject to change without notice
4
START-UP AND PARAMETER SETTINGS
4.2
Fitting the sender/receiver unit
4.2.1
Adapting the sender/receiver unit to the flow direction
Versions for internal duct pressure up to +10 kPa
Fig. 32: Probe alignment
The sender/receiver unit is delivered for vertical fitting as standard when the duct direction
(horizontal or vertical) is not specified in the order. In this case, the following steps are
required for horizontal fitting:
▸
Loosen knurled screws (1) and pull probe flange (2) off electronics unit (3).
▸
Loosen fastening screws (4), pull the probe with electronics unit carefully out of
enclosure (5), turn it 90° and fasten it again.
▸
Fit the probe flange so that purge air connection (6) is underneath when fitted.
Fig. 33: Adapting the sender/receiver unit to the flow direction
Vertical duct
The gas loaded with particles
must flow freely through the
measuring volume.
Horizontal duct
Flow direction