![background image](http://html1.mh-extra.com/html/sick/dusthunter-sp100/dusthunter-sp100_operating-instructions-manual_1264547042.webp)
42
8012426/YWL2/3-0/2016-08| SICK
O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER SP100
Subject to change without notice
3
ASSEMBLY AND INSTALLATION
3.3
Electrical installation
3.3.1
Electrical safety
3.3.1.1
Properly installed power isolating switches
3.3.1.2
Lines with correct rating
3.3.1.3
Grounding
the devices
3.3.1.4
Responsibility for system safety
WARNING:
▸
Observe the relevant safety regulations as well as the safety notices in
“Important Information”, page 7
during all installation work.
▸
Take suitable protection measures against possible local hazards or
hazards arising from the equipment.
WARNING:
Endangerment of electrical safety during installation and maintenance work
when the power supply is not switched off.
An electrical accident can occur during installation and maintenance work
when the power supply to the device or lines is not switched off using a power
isolating switch/circuit breaker.
▸
Before starting work on the device, ensure the power supply can be
switched off using a power isolating switch/circuit breaker in accordance
with DIN EN 61010.
▸
Make sure the power isolating switch is easily accessible.
▸
An additional disconnecting device is mandatory when the power isolating
switch cannot be accessed or only with difficulty after installation.
▸
The power supply may only be activated again after the work or for test
purposes by personnel carrying out the work under consideration of valid
safety regulations.
WARNING:
Endangerment of electrical safety through power line with incorrect rating.
Electrical accidents can occur when the specifications for replacement of a
removable power line have not been adequately observed.
▸
Always observe the exact specifications in the Operating Instructions
(Technical Data Section) when replacing a removable power line.
CAUTION:
D
evice damage through incorrect or missing grounding.
▸
During installation and maintenance work, it must be ensured that the
protective grounding to the devices and/or lines involved is effective in
accordance with EN 61010-1.
WARNING:
Responsibility for the safety of a system.
▸
The person setting the system up is responsible for the safety of the system
in which the device is integrated.