b
If necessary, use a spirit level to check that the components are parallel (
&
).
&
5.4.1
Mounting the QuickFix bracket
Overview
The active and passive units are each mounted using 2 QuickFix brackets.
The QuickFix bracket consists of 2 individual parts that are pushed into each other. The
two individual parts are connected using an M5 screw, and the housings of the active
and passive units are clamped with form-fit clamping.
The two mounting surfaces for the brackets of the active and passive units must be
parallel and lie on the same plane.
Important information
NOTE
The following should be considered when mounting the QuickFix bracket:
•
Select the appropriate length of the M5 screw to prevent any risk of injury from an
overrun
•
When selecting the screw length, observe the wall thickness and the depth of the
countersunk screw of the QuickFix bracket,
NOTE
The QuickFix bracket has a cable guide. Depending on the installation, the cable guide
can make mounting easier.
Mounting the QuickFix bracket on a machine or profile frame
Table 11: Side and rear mounting with the QuickFix bracket
mounting
method
Description
On the side
1)
Fasten the M5 screw to the machine or profile frame through the QuickFix
bracket. A screw nut or threaded hole is required on the machine or profile
frame (
!
).
Fasten the M5 screw to the QuickFix bracket through the machine or profile
frame. A screw nut is required for each QuickFix bracket (
"
).
Fasten the M5 screw to the profile frame through the QuickFix bracket. A
sliding nut is required on the profile frame (
§
).
5
MOUNTING
54
O P E R A T I N G I N S T R U C T I O N S | deTem4 A/P
8024782/2019-11-19 | SICK
Subject to change without notice