- 39 -
3.3 System Memory Configuration
The FX83 mainboard has two 184-pin DIMM slots that allow you to install
from 64MB up to 2GB of system memory. Each 184-pin DIMM (Dual In-line
Memory Module) slot can accommdate 64MB, 128MB, 256MB, 512MB,
and 1GB of PC1600, PC2100, PC2700 or PC3200 (2.6V) compliant 2.5V
single (1 Bank) or double (2 Bank) side 64-bit wide data path DDR SDRAM
modules.
1. Install Memory :
Install memory in any or all of the banks. The combination shown as follows.
Note: You do not need to set any jumper to configure memory since the BIOS
utility can detect the system memory automatically. You can check the total
sytstem memory value in the BIOS Standard CMOS Setup menu.
Don't support double-sided X16 DDR DIMMs.
2. Upgrade Memory:
You can easily upgrade the system memory by inserting additional
DDR SDRAM modules in available DIMM slots. The total system
memory is calculated by simply adding up the memory in all DIMM
slots. After upgrade, the new system memory value will automatically
be computed and displayed in the field "Standard CMOS Setup" of
BIOS setup program.
Desity
64M
128M
256M
512M
Device width
X8
X16
X8
X16
X8
X16
X8
X16
Single/Double
SS/DS
SS
SS/DS
SS
SS/DS
SS
SS/DS
SS
184pin DDR
DIMMs
64/128MB 64/128MB 128/256MB
128/256MB
256/512MB
256/512MB
256/1024MB
256/1024MB
