t
t
h
h
e
e
r
r
m
m
o
o
d
d
u
u
a
a
l
l
T
T
D
D
A
A
1
1
5
5
/
/
2
2
5
5
3
3
0
0
/
/
4
4
0
0
SHT Heiztechnik,
aus Salzburg
Operating instructions
M21/HB M27/GB
Page 19
SHT Heiztechnik aus Salzburg GmbH, A-5020 Salzburg-Bergheim, Rechtes Salzachufer 40 Tel. 0662-450444-0, Fax-DW 9
Our current general terms and conditions apply.Errors, printing faults and technical changes reserved
7.6
Menu item „Dom.Water“
•
Dom.Water Monitor
Actual-Temp.:
Here, the current temperature is displayed.
Loading-Start:
If the actual temperature falls below this value, the loading starts.
Loading-Stop:
If the actual temperature exceeds this value, the loading stops.
Operation Mode:
Here, the operation mode is selected:
>Auto High/Low:
The temperature value "Loading-Start" is selected automatically by a time
schedule selected under "Dom.Water Timeprog". You can set a high (high
temperature) or low (Low temperature) value; see
"Dom.Water Temp.Setup"
>High-Temp.<:
The high loading-start value applies at any time (Timeprog inactive).
>Low-Temp.<:
The low loading-start value applies at any time (Timeprog inactive).
>Frostprotection<:
The frost protection loading-start value applies at any time (Timeprog
inactive) – this value is preset and cannot be changed.
Status line
:
Here, the current status of the Dom.Water is displayed; the following texts
are possible:
"Water warm !"
The water is hot, re-loading starts only after the "Actual-Temp." falls below
the "Loading-start" value.
"Heating up"
The water is being heated (loading pump running).
"Buffer cold !"
Water is being heated, buffer still too cold, if burner switch is set to "ON",
pellet burner starts to load the buffer.
"Frostpr.running !"
Operation mode is set to "Frost protection", actual temperature has fallen
below frost protection setting.
"Probe faulty !"
The Dom.Water probe is defective or not connected.
status line