Shop fox W1702, Manual

Page: 43 / 75

-22-
FG<I8K@FEJ
JkXikLg
Once assembly is complete and adjustments
have been made, the shaper is ready for start
up. Always pay attention to any unusual noises
and vibrations on every start up, as well as
make sure the shaper operates as intended.
(%
D8B< JLI<
that the fence, any accessories,
Jigs, spindle, cutter, or router bit adapter
being used is tight and no loose items are on
the table.
)% Put your safety glasses on, and start the
shaper by turning the switch to the forward
position. Be sure to have your finger poised
to stop the machine if there is a problem.
*% Once the machine is running, listen for any
unusual noises coming from the shaper. The
shaper should run smoothly with little or no
vibrations.
› If there is an unusual noise or vibration,
shut the machine off immediately. DO
NOT run the shaper any further until the
problems are corrected. Refer to the
KiflYc\j_ffk`e^ section on GX^\ ** for
possible causes and solutions.
› If the problem continues and cannot be
easily identified, contact our customer
service department.
FG<I8K@FEJ
B<<G cffj\ Zcfk_`e^
ifcc\[lgXe[flkf]k_\
nXp f] dXZ_`e\ip Xe[
b\\g_X`iglcc\[YXZb%
LEGCL>$ k_\ gfn\i
Zfi[ Y\]fi\ pfl [f Xep
Xjj\dYcp# X[aljkd\ekj#
fi dX`ek\eXeZ\ kXjbj
Fk_\in`j\#
j\i`flj
g\ijfeXc `ealip kf pfl
fifk_\ijdXpfZZli
N<8IpflijX]\kp^cXjj\j
Xe[ [ljk dXjb [li`e^
dXZ_`e\ fg\iXk`fe%
=X`cli\ kf Zfdgcp dXp
i\jlck`ej\i`fljg\ijfeXc
`ealip%