Shop fox W1702, Manual

Page: 34 / 75

-13-
?Xe[n_\\c
The handwheel comes installed from the
factory; however, you will need to install the
crank handle. NOTE: for each revolution of
the handwheel, the spindle moves up or down
approximately 0.045".
Kf`ejkXcck_\ZiXeb_Xe[c\#[fk_\j\jk\gj1
(%
Thread the crank handle into the hole on the
face of the handwheel as shown in =`^li\
(.
.
)%
Using a 14mm open-end wrench, tighten the
crank handle securely, making sure the hand
wheel rotates freely.
=`^li\(.% Attaching the crank handle.
?fc[$;fnej
The hold-downs hold the workpiece against the
fence and the table. NOTE: Remove the hold-
down assembly when not in use.
Kf`ejkXcck_\_fc[$[fnej#[fk_\j\jk\gj1
(% Install two aluminum hold-down brackets
onto each of the hold-down bars as shown in
=`^li\(, .
)% Insert the long end of the hold-down bar
through the hole in the fence mount as
shown in
=`^li\(, .
*%
Adjust the hold-down fence mount to the
desired position along the top edge of the
fence casting.
+%
Screw in, but do not tighten, the
1 ⁄
4
"-20 x
3 ⁄
8
" setscrews into the aluminum hold-down
brackets as shown in =`^li\(, .
,% Slide each hold-down into the slot between
the aluminum hold-down bracket and hold-
down bar.
-% Position each of the hold-downs into place for
your workpiece as shown in =`^li\ (- , and
tighten the setscrews in the fence mounts and
the aluminum hold-down brackets.
=`^li\(,% Assembling hold-down mechanism.
=`^li\(-% Assembled hold-down mechanism.
?fc[$[fne
9iXZb\k
8JJ<D9CP