Shop fox W1702, Manual

Page: 39 / 75

-18-
KXYc\@ej\ikj
The table inserts are necessary for the safe
operation of the shaper. Two inserts are provided
allowing for three different opening sizes to
be achieved. Use the smallest-size opening for
a cutter to reduce wood chips falling into the
machine, which could cause flying debris. Using
the smallest-size opening also covers any unused
portion of the bit below the surface of the table,
thus reducing the chance of operator injury.
KfX[aljkk_\kXYc\`ej\ikj#[fk_\j\jk\gj1
(%LEGCL>K?<J?8G<I
)% Using a screwdriver, remove the three
Phillips
®
head screws holding the cast iron
insert in the table. See =`^li\),%
*% Using a straightedge as a guide, turn the
barrel-head screws either way until the
insert is flush with the top of the table as
shown in
=`^li\j)+ and ),%
+% Once the entire insert is flush with the table
top, reinsert the three Phillips ® head screws
and tighten.
=`^li\),% Use a straightedge to make sure
insert is flush with table.
=`^li\)+% Barrel-head screw.
8;ALJKD<EKJ