Shop fox W1702, Manual

Page: 40 / 75

-19-
Glcc\p8c`^ed\ek
Pulley alignment is important to the performance
of your shaper. If the pulleys are just slightly
out of alignment, the shaper may suffer from
power loss as well as decreased V-belt life. The
pulleys need to be parallel with one another for
optimum shaper performance.
KfXc`^ek_\glcc\pj#[fk_\j\jk\gj1
(%LEGCL>K?<J?8G<I
)% Remove the motor cover from the side of the
shaper.
*% Hold a straightedge up to the pulleys to
determine if they are aligned correctly as
shown in
=`^li\)-%
+% If the motor pulley is not aligned with the
spindle pulley, loosen the four motor mount
bolts as shown in
=`^li\). .
,% Wiggle the motor until the pulley is aligned
with the spindle pulley.
-% If the spindle pulley is not aligned with the
motor pulley, loosen the bolt on the spindle
slide that holds the spindle in place as shown
in
=`^li\)/%
.% Place a pad on the floor underneath the
spindle to prevent damage if it falls to the
floor.
/% Slowly wiggle the spindle up or down into
alignment with the motor pulley. Wiggle the
spindle slowly so the spindle does not slide
too fast or drop to the floor.
0% After you adjust the pulleys, check the
alignment with the straightedge again. Once
you are satisfied with the results, tighten
down all the fasteners, and recheck one more
time after all the fasteners are secure.
=`^li\)-%
Use straightedge to check V-belts.
=`^li\).% Loosening motor mount bolts.
=`^li\)/% Loosening spindle cartridge bolt.
8;ALJKD<EKJ