62
11
. Application Functions
11.2
Liquid Density Measurement
Liquid density measurement refers to the measurement of the weight of a reference solid of a known
volume in air and in the sample liquid. Density of the liquid is calculated from these two values.
The display unit for liquid density is “d”. The data output unit is DL.
Note
Use of the optional SMK101A, or SMK-102 Specific Gravity Measurement Kit
(refer to
A-4
.) is recommended for efficient measurements. When using the
Gravity Measurement Kit, refer to the instruction manual of the kit. Follow the
instruction below when a hanging pan and a tank are prepared by the user.
1
Select menu item
61-1
,
61-2
in advance.
61-1
: Select either the hold display mode or the
continuous display mode for the specific gravity
value display. Press the [CAL] key repeatedly
until [SG HoLd] appears.
Each time the [O/T] key is pressed the “
”
symbol on the left side of the display turns on or
turns off. The display is configured as shown
below according to the on/off state of “
”
“
”on : Hold display mode
“
”off : Continuous display mode (the specific
gravity value is updated according to the change
of weight in water)
Press the [POWER] key repeatedly to return to
the mass display.
Press the [CAL] key to display the sinker volume
setting screen.
61-2
: Enter the value for the volume (cm
3
) of the
reference weight. Refer to
4.4
for numerical value
input.
After entering the value, set using the [O/T] key,
then press the [POWER] key two times to return
to mass display.
2
Remove the below-weigh hook cap from the
bottom of the balance to expose the below-
weigh hook.
3
Hook the hanging pan, and then immerse the
hanging pan in a tank containing the sample
liquid.
Summary of Contents for UP1023X
Page 3: ...No text...
Page 124: ...109 2 4 1 3 5 6 7 11 13 12 8 9 10 14 Appendices...
