D S P M O D E
(DTS
Dolby Digital
Dolby Pro Logic) Dolby 3 Stereo
(Stereo)
Church Stadium
Hall Theater
17
Speaker placement
ENJOYING SURROUND SOUND
Select the desired surround mode.
1
When selecting the DTS mode, the
Dolby Digital mode or the
Dolby Pro Logic mode.
The DTS mode is available only for DVD,LD,
AUX/TV and CD as input source.
The Dolby Digital mode is available only for DVD, LD
and AUX/TV as input source.
To enjoy the DTS mode or the Dolby Digital mode, be
sure that the program source and the corresponding
digital input is selected. If not, no sound will be heard.
When LDP is selected, only the RF digital input will
work in the Dolby Digital mode.
(Refer to “When CD, DVD, LD or AUX/TV is
selected as input source” on page 14.)
When some Dolby Digital program sources encoded into
2 channel format is played in the Dolby Digital mode,
“DD + Pro Logic” is displayed.
“( )”:Remote control only.
When canceling the surround mode for normal stereo
operation.
When selecting a surround mode among the Dolby 3
Stereo, Theater, Hall, Stadium and Church modes.
Each time the DSP mode button or the SURROUND
MODE button is pressed, the surround mode changes
as follows;
Surround sound effect will not work properly if the signal passes through a graphic equalizer.
Please refer to your equalizer operating instructions for guidance on switching off (or defeating) the equalizer.
S T E R E O
To obtain the best surround sound effect in your home, place the speakers as
follows;
Front speakers : Place each front speaker about 1m (40 ) from the TV set.
Center speaker : Place the center speaker either above or below the TV set
to assure good visualization of center channel program.
Rear speakers : Place the rear speakers approximately 1m (40 ) above the
ear level of a seated listener directly to the left or right of
the main listening position or at the same height but
slightly behind the main position.
Subwoofer : Place the powered subwoofer by a wall or corner of the room
for best sound.
The ideal surround system consists of all the speakers listed above. The
ideal DTS Digital Surround system uses full range speakers for all
positions including both front speakers, both rear speakers and the center
speaker.
However, if you don’t have a center speaker, a subwoofer or rear speakers,
select the best possible surround mode with the available speakers.
Note: To avoid interference with the TV picture, use only magnetically
shielded center and front speakers.
D T S
D I G I TA L
P R O - L O G I C
or
or
or
ENGLISH
