POWER
ON/OFF
STANDBY
S TA N D B Y
13
L I S T E N I N G T O A P R O G R A M
Note: Before operating this pre amplifier with the supplied remote control, refer to “Universal Remote Control” on
page 9 for details about operation.
Before operation
TA P E 2 M O N I T O R
I N P U T S E L E C T O R
Select the desired input source.
1
The STANDBY button lights up in red. This
means that the unit is connected to the AC outlet
and a small amonut of current is retained to
support the memorized contents and operation
readiness.
To switch the power off, push the POWER switch
again.
Then the power is cut off and the STANDBY
button goes off.
The STANDBY button lights up in green and the
unit is turned on and enters the operating mode.
In the standby mode, if the INPUT SELECTOR
button is pressed on the remote control, the unit is
turned on automatically and the desired input is
selected.
enter the standby mode.
In the operating mode, to enter the standby mode.
In the standby mode, to turn the power on.
The STANDBY button lights up in red.
Each time the INPUT SELECTOR knob is rotated, the input
source changes as follows:
Each time the VCR1 button on the remote control is pressed,
the input source changes as follows:
When the TAPE 2 MONITOR button is set to on and TAPE
2 MONITOR button on the front panel lights up in green,
other inputs can not be heard from the speakers.
To listen to a input source other than TAPE 2 MONITOR, be
sure to set the TAPE 2MONITOR button to off.
TAPE 2 MONITOR function
You can connect either a tape deck or a graphic
equalizer to the unit’s TAPE 2 MONITOR jacks.
When listening to the component connected to
these jacks,set the TAPE 2 MONITOR button to on.
If you connect a 3-head tape deck, you can listen to the
sound being recorded during recording, instead of the
source sound.
For further details, refer to the operating instructions
of the component connected.
When selecting the 6-CH DIRECT inputs as desired.
SURROUND mode
Input source
or
or
or
or
PHONO
TUNER
CD PLAYER
TAPE 1
DVD PLAYER
(frequency display)
AUX/TV
VIDEO3
VIDEO2
VIDEO1
LD PLAYER
VIDEO 1
VIDEO 2
VIDEO 3
6-CH DIRECT
DIGITAL or ANALOG input
The 6 separate analog signals from 6-CH decoder connected to
this unit pass through the tone(bass,treble) and volume circuits
only and directly transfer to the LINE OUTS of this unit.(In
case that the TAPE 2 MONITOR button is set to on, the TAPE
2 MONITOR button is automatically set to off.)
Press the 6-CH DIRECT button again to cancel the 6-CH
direct function.
These 6 separate analog signals can be heard only, not
recorded.
6 - C H D I R E C T
C D
P L A Y E R
D T S
O
(
p t )
ENGLISH
