CAUTION:
TO PREVENT ELECTRIC SHOCK,
DO NOT REMOVE COVER. NO USER-SERVICEABLE
PARTS INSIDE.REFER-SERVICING TO QUALIFIED
SERVICE PERSONNEL.
5
Do not plug the AC input cord into the wall AC outlet until all connections are completed.
Be sure to connect the white RCA cord to the L (left) and the red RCA cord to the R (right) jacks when making audio
connections.
Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations.
A 75
Ω
outdoor FM antenna may be used to further improve the reception.
Disconnect the indoor antenna before replacing it with the outdoor one.
Place the AM loop antenna as far as possible from the receiver, TV set, speaker wires and the AC input cord.
Point it in the direction that offers the best reception.
If the reception is poor with the AM loop antenna, an AM outdoor antenna can be used in place of the AM loop antenna.
Make connections firmly and correctly. If not, it can cause loss of sound, noise or damage to the pre amplifier.
If the electricity fails or the AC input cord is left unplugged for about 2 weeks, the memorized contents will be cleared.
Should this happen, memorize them again.
Connect this to the DIGI LINK jack of the external Sherwood
component that uses the DIGI LINK ll or lll remote control
system.
CONNECTING ANTENNAS
DIGI-LINK STEREO DOUBLE CASSETTE DECK DD-5080C
AUTO REVERSE
PLAY/AUTO TAPE SELECTOR
RECORD & PLAY/AUTO TAPE SELECTOR
HX-PRO
AUTO REVERSE
RESET
A/B
MODE
R PLAY
DUBBING
O/O
CD SUN REC
HIGH
NORMAL
AMS
AMS
EJECT
REC BALAMCE
REC LEVEL
PHONES
POWER
MIC MIX
MIC
SOURCE
L
R
0 10
MIC
REVERSE
T SIZE
MEMORY
B/C/OFF
COUNTER
B
A
DIGI-LINK STEREO DOUBLE CASSETTE DECK DD-5080C
AUTO REVERSE
PLAY/AUTO TAPE SELECTOR
RECORD & PLAY/AUTO TAPE SELECTOR
HX-PRO
AUTO REVERSE
RESET
A/B
MODE
R PLAY
DUBBING
O/O
CD SUN REC
HIGH
NORMAL
AMS
AMS
EJECT
REC BALAMCE
REC LEVEL
PHONES
POWER
MIC MIX
MIC
SOURCE
L
R
0 10
MIC
REVERSE
T SIZE
MEMORY
B/C/OFF
COUNTER
B
A
CONNECTING AUDIO COMPONENTS
CONNECTING SYSTEM CONTROL
To select the gain and the input impedance of the phono input
circuitry according to the phono cartridge type of the turntable
connected, set the MM/MC switch to either
for MC(moving
coil) or
for MM(moving magnet).
The TAPE 2 MONITOR IN/OUT jacks may also be connected
to the LINE OUT/IN jacks of an optional graphic equalizer.
CONNECTING 6-CH DIRECT INPUTS
Use these jacks to connect the corresponding
analog outputs of a separate 6-CH decoder or DVD
player with 6-CH output. (For details, see the
operator’s manual of the other component.)
ENGLISH
