Shaver HD-12-H, Operator'S Manual

Page: 10 / 56

Stabilizer Legs (optional)
1 . Place three-point hitch weldment (K1)
upside down on the floor. Install stabilizer
leg brackets (K2), with stabilizer legs (K7)
installed, over the cross tube, as shown.
Tighten two leg bracket bolts (K3) to secure
the brackets to the cross tube.
(K1) Three-Point Hitch Weldment. (K2) Leg Bracket.
(K3) Leg Bracket Bolt. (K7) Stabilizer Leg.
2 . If the short channel bracket was mounted
at the most common center position in
Step 2, set stabilizer leg (K7) height at 8”
(20.3 cm) measured from three-point hitch
weldment (K1) cross tube to the stabilizer
leg base plate, as shown. Tighten the
stabilizer leg lock bolts.
(K1) Three-Point Hitch Weldment. (K2) Leg Bracket.
(K7) Stabilizer Leg.
NOTE : If a set of six threaded holes other
than the center set, were used to mount short
channel bracket (D2), the height of the legs
will need to be adjusted accordingly.
3 . Turn over three-point hitch weldment (K1)
and set it on stabilizer leg (K7) base plates,
as shown.
(K1) Three-Point Hitch Weldment. (K7) Stabilizer Legs.
Base Plate
1 . Remove the four carriage bolts, washers,
and nuts from base plate (F2). Save
hardware for reuse.
(F2) Base Plate.
10