19
4
.
Apply a light film of a good quality grease
to the pivot shaft and attach roller bracket
(
I
6) to swing arm handle (
I
5) with roller
bracket nut (
I
9). Tighten the nut until
seated and then loosen 1/4 to 1/2 turn.
NOTE
: Roller bracket (
I
6) must swivel freely
on swing arm handle (
I
5).
(
I
5) Swing Arm Handle. (
I
6) Roller Bracket.
(
I
9) Roller Bracket Nut.
5
.
Attach one end of latch spring (
I
10) to
swing arm handle (
I
5), as shown. Secure
with spring retainer flat washer (
I
11
)
and
Lynch pin (
I
13
)
.
(
I
5) Swing Arm Handle. (
I
10) Latch Spring.
(
I
11) Spring Retainer Flat Washer. (
I
13) Lynch Pin.
6
.
Install the swing arm assembly.
a
.
Apply a light film of a good quality
grease to the pivot shaft on swing arm
handle (
I
5).
b
.
Start the pivot shaft into the main
bracket tube, as shown. Slide the open
spring eye over the main bracket
anchor rod.
NOTE
: Swing arm handle (
I
5) will be below
safety arm frame (
I
2) bracket stop at this
point.
c
.
Secure the spring with flat washer (
I
11)
and Lynch pin (
I
13).
(
I
11) Flat Washer. (
I
13) Lynch Pin.
19
Summary of Contents for HD-12-H
Page 44: ...44 Service Parts 44 Driver Assembly ...
Page 46: ...46 Hydraulic Base Plate Assembly ...
Page 55: ...Notes 55 ...