Shaver HD-12-H, Operator'S Manual

Page: 14 / 56

b . Assemble the control valve linkage.
Install levers (G5), control valve safety
lever (G7), return spring (G10), and
lever linkage (G11, G12, G23), as
shown. Secure with cotter pins (G13).
Refer to photographs for correct
linkage placement and orientation.
(H1) Hydraulic Control Valve Linkage.
(G5) Control Valve Levers. (G7) Control Valve Safety
Lever. (G10) Safety Lever Return Spring. (G11) Clevis
Pin. (G12) U-Link. (G13) Cotter Pin(s). (G23) Flat Link.
2 . Install hydraulic valve (H1) on short
channel bracket (D2) using three
5/16-18 x 3” valve mounting bolts (G2),
washers (G3), and nuts (G4). Do not
over-tighten the hardware, which can warp
the valve body.
(D2) Short Channel Bracket. (G2) 5/16-18 x 3” Bolt.
(G3) 5/16” Washer. (G4) 5/16-18 Nut.
(H1) Hydraulic Control Valve.
IMPORTANT NOTICE
The hydraulic valve and cylinder(s) can be
damaged by contamination (dirt and debris)
from the oil in the tractor or power source.
Ensure the oil is clean and properly filtered
before connecting the Post Driver to a hydraulic
power source. Failure to follow oil cleanliness
standards voids the Shaver Post Driver
warranty.
14