Sharp AR-C330 Key operators, Operation Manual

Page: 42 / 186

2-18
CHAPTER
2
JOB MEMORY
Frequently used job programs can be stored in one of nine storage
registers. This is convenient for quick job recall without losing time
manually reprogramming each aspect of the job.
●
All functions that can be set in the copy mode except the copy
quantity setting can be stored in the job memory.
●
If any function which has been stored in a job program is modified
by a key operator program, the key operator settings will supercede
the previous setting.
★
KEY OPERATOR Job memory replacement/deletion can be
prohibited. See page 8-19.
Storing a job program
1
Press the PROGRAM ( ) key.
●
The JOB PROGRAMS screen will appear on the touch panel.
2
Press the “STORE/DELETE” key on the touch panel.
● To cancel the job memory mode, press the “EXIT” key or the
CLEAR ALL (
CA
) key.
3
Select a program number from 1 to 9 on the touch panel.
●
The numbers which are highlighted are job registers which
already contain job programs.
●
If a program number containing a registered job program is
selected, a message will appear to confirm the selection. To
replace a stored job program with a new program, press the
“STORE” key and proceed to the next step.
To cancel replacement, press the “CANCEL” key.
4
Make all copier selections to be stored.
NOTE:
When you store colour balance settings, make settings before
pressing the PROGRAM (
) key in step 1 because sample
copies cannot be made after pressing the PROGRAM ( ) key.
5
Press the “OK” key to complete the storage.
MAKING COPIES
Job memory
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
MAKE COPIER SELECTIONS AND PRESS
[OK].
DUPLEX
OK
CANCEL
A4
A3
B4
AUTO A4
STORE/DELETE RECALL
JOB PROGRAMS
STORE/DELETE RECALL
PRESS PROGRAM NUMBER.
EXIT