7-22
CHAPTER
7
OPTIONAL EQUIPMENT
Finisher (AR-FN4)
FINISHER (AR-FN4)
Staple cartridge replacement
When the staple cartridge is empty, the message “
SLIDE THE
FINISHER AWAY FROM THE COPIER AND ADD STAPLES.
” will
appear.
Replace the staple as follows:
1
While holding the finisher release lever, slide the finisher
away from the copier.
2
Pull out the staple box.
●
To prevent bumping or scraping your hand during removal of the
staple box, proceed as shown in the illustration and as follows:
Grasp the staple box with your thumb and index finger, and place
the heel of your hand against the finisher frame as shown with
arrow
1
in the illustration.
Remove the staple box in the direction of the arrow
2
by
squeezing with your fingers and rotating against the heel of your
hand.
3
Remove the empty staple cartridge from inside the
staple box.
4
Insert the new staple cartridge into the box until it clicks
in place.
●
Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
●
The cartridge holds 3,000 staples.
NOTE:
Be sure to remove the rear paper and tape before inserting the
cartridge.
Summary of Contents for AR-C330 Key operators
Page 94: ......
Page 146: ......
Page 184: ......
Page 186: ...AR C330 PRINTED IN JAPAN 2004H KS1 TINSE2778FCZZ ...