7
Product Version 1.0 | Revision A | Released 2022-4-21
BEFORE INSTALLING THIS PRODUCT
Please visit the SGM official website at www.sgmlight.com for the latest version of this user
manual/ safety information leaflet. Due to continuous improvements, the instructions may
change without notice. SGM always recommends the latest available firmware version from
EXTERNAL CLEANING AND VISUAL INSPECTION OF THE FIXTURE
All users of the SGM fixtures should regularly clean those parts of the fixture directly exposed to
the elements, such as the external housing and front lenses. Additionally, all owners of the SGM
fixtures must periodically check the external housing of the fixture for structural breaks, deteri
-
oration, cracked lenses, or loose screws. To ensure proper operation, but also to prevent the risk
of potential accidents, do not use the fixture if the lens, housing, or power cables are damaged.
If parts of the fixture appear to be missing, cease use immediately and contact SGM support.
WIRING AND CONDUIT/ CONTAINMENT
SGM fixtures supplied with power and data cable leads are not intended for installation in per
-
manently installed conduit or containment. When installing the fixtures in a permanent instal
-
lation, ensure cable leads are installed as a service loop to an appropriately rated junction box
using suitable cable strain reliefs/glands. All installed fixtures must be securely mounted, and
service loop appropriately protected for installation location. All electrical wiring and connec
-
tions should be completed by a qualified electrician.
SAFETY PRECAUTIONS
When using electrical equipment, basic safety precautions should always be followed including
the following:
•
Do not mount near gas or electric heaters.
•
Permanently installed equipment should be mounted in locations and at heights where
it will not be readily subjected to tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an
unsafe condition.
•
Do not use this equipment for other than intended use.
•
Refer service to qualified personnel or authorized service centers.
•
Do not look directly into the beam for long periods of time, when the fixture is on.
•
The fixture shall, under no circumstance, be covered with insulating material of any kind.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
