6
Product Version 1.0 | Revision A | Released 2022-4-21
SAFETY INFORMATION
SGM fixtures are intended for professional use only. They are not suitable for household use.
Les fixtures SGM sont impropre à l’usage domestique. Uniquement à usage professionnel.
This product must be installed in accordance with the applicable installation code by a person
familiar with the construction and operation of the product and the hazards involved.
Ce produit doit être installé selon le code d’installation pertinent, par une personne qui connaît
bien le produit et son fonctionnement ainsi que les risques inhérent.
DANGER! RISK OF ELECTRIC SHOCK DO NOT OPEN THE DEVICE!
•
Always power off/unplug the fixture before removing covers or dismantling the product.
•
Ensure that the mains power is cut off when wiring the device to the AC mains supply.
•
Ensure that the device is electrically connected to earth (ground).
•
Do not apply power if the device or mains cable is in any way damaged.
•
Do not immerse the fixture in water or liquid.
WARNING! TAKE MEASURES TO PREVENT BURNS AND FIRE!
•
Install in a location that prevents accidental contact with the device.
•
Install only in a well-ventilated space.
•
Install at least 0.3 m (12 in.) away from objects to be illuminated.
•
Install only in accordance with applicable building codes.
•
Ensure a minimum clearance of 0.3 m (12 in.) around the cooling fans
•
Do not paint, cover, or modify the device, and do not filter or mask the light.
•
Keep all flammable materials well away from the device.
ALLOW THE DEVICE TO COOL FOR 15 MINUTES AFTER OPERATION BEFORE TOUCHING IT
CAUTION: EXTERIOR SURFACE TEMPERATURE AFTER 5 MIN. OPERATION = 42°C (108°F).
STEADY STATE = 48°C (118°F).
WARNING! TAKE MEASURES TO PREVENT PERSONAL INJURY. DO NOT
LOOK DIRECTLY AT THE LIGHT SOURCE FROM CLOSE RANGE.
•
Take precautions when working at height to prevent injury due to falls.
•
For Permanent Outdoor Installations (POI), ensure that the fixture is securely fastened to
a load-bearing surface with suitable corrosion-resistant hardware.
•
For a temporary installation with clamps, ensure that the quarter-turn fasteners are
turned fully and secured with a suitable safety cable. The standard safety wire cable must
be approved for a safe working load (SWL) of 10 times the weight of the fixture, made of
a grade AISI 316 steel, and it must have a minimum gauge of 4 mm.
•
For elevated installations, secure the fixture with suitable safety cables, and always com
-
ply with relevant load dimensioning, safety standards, and requirements.
WARNING! READ THE FOLLOWING SAFETY PRECAUTIONS CAREFULLY BE
-
FORE UNPACKING, INSTALLING, POWERING OR OPERATING THE DEVICE.
