Sesamo PROSWING R, Manual Instructions

Page: 9 / 48

9
SESAMO PROSWING
- Close the cover (Fig.9 Part.A) of the guide.
- Closed the right cap (Fig.9 part.E) and left cap (Fig.9 part.D) with the supplied
screws.
- Proceed with the adjustment of the spring [vedi paragrafo “[see paragraph “Spring
adjustment”].
Before tighten the arm extension, please check the distance between the guide and the upper
part of the arm, it should be around 17 mm
ATTENTION: After installing guide and slide arm, ALWAYS check the Switch on left
position in Fig.16 .
PUSH ARM INSTALLATION
Push arm is used when automatism is installed on the opposite side of door opening.
ATTENTION: For a correct positioning always refer to the hinge axis and gear motor axis,
as shown in Fig.7 (door opening LEFT) ed 8 (door opening RIGHT).
ATTENTION: final tightening of the screws must be performed only after checking arm
can easily rotate under door jamb.
FIX PUSH ARM TO THE DOOR
- Insert washer (Fig.11 part.B) and screw (Fig. 11part.C) on the arm extension (Fig.
11 part.A).
- Fix the first part of the articulated push arm (Fig. 11 part.D) in the slot of the arm
extension, as indicated in Fig. 11 and tight screws (Fig. 11 part.E).
ATTENTION THE MAX. TORQUE TO BE USED TO TIGHTEN SCREW “E” FIG.12 IS 10.5 N/m
- Unscrew 3 scews M8 x 16 (Fig.10 part.B) to leave independent the part of the arm
you will fix to the door leaf.
- Adjust the lenght of the arm following the calculation in Fig.13
- Screw, without tighten, 3 screws M8 x 16 (Fig. 10 part.B) to joint the two part of
the articulated arm.
- Drill the door leaf as indicated on Fig. 7 e 8.
- Position the door leaf on the desired opening point
- Fix the arm extension (Fig.10 part.A) of the pushing arm onto the above profile of
the wing through adequate screws.
ATTENTION: fix door bracket considering door material in case using a
reinforcement.
- Tighten screw (Fig. 12) to tension the spring up to the end of the plate (Fig.12 part.
B) matches the line indicating field EN4 (quote L=0).
- Fix the arm extension (Fig.11 part.A) into gear motor shaftto the door axis.
- Tight screw (Fig.11 part.C) until arm extension is well fixed to gear motor shaft
- Continue with sp ring adjustment (see paragraph “Spring adjustment”).