Sesamo PROSWING R, Manual Instructions

Page: 3 / 48

3
SESAMO PROSWING
Thank you for choosing this product. For best automatism performance, Sesamo recommends
you carefully read and follow the installation and use instructions found in this manual.
Installation of this automatism must only be performed by the professionally qualified
personnel for whom this manual is addressed. Any errors during installation may be harmful
to people or things. Packaging material (wood, plastic, cardboard, etc.) should not be
scattered in the environment or left within the reach of children as potential sources of
danger. Every installation phase must be performed in accordance with the regulations in
force and following Good Technique standards. Before beginning installation make sure that
the product is integral and has not been damaged during transportation or by poor storage
conditions. Before installing the product make sure that each architectural and structural
element of the entrance (girder fastening surfaces, casings, guide, etc.) is appropriate and
sufficiently robust to be automated. Conduct a careful risk analysis and make suitable
modifications to eliminate conveyance, crushing, cutting and hazardous areas in general. Do
not install the product in environments where gas, steam or inflammable fumes are present.
The manufacturer is not
liable for any neglect of “good technique” or specific regulations in
the construction of the casing to be motorized and any collapse of the same. All automatic
entrance safety and protection devices (photocells, active sensors, etc.) must be installed in
accordance with the regulations and directives in force, with the completed risk analysis,
system type, use, traffic, forces and inertia in play. Pay careful attention to area where the
following may occur: crushing, cutting, conveyance and any other type of hazard in general
applying, if necessary suitable indications. Indicate the motorized door identification
information on every installation. Make sure that the upstream electrical system is correctly
dimensioned and has all the opportune protections (circuit breakers and fuses). Only use
original spare parts in maintenance and repairs. Do not tamper or alter devices in the
automatism and all the safety devices in the control panel for any reason. The manufacturer
is not liable if parts within the automatism are altered or tampered with or if safety devices
other than those indicated by the manufacturer are used in the system. The automatism
installer must provide the automatic entrance manager with the use manual and all the
information required for correct use in automatic and manual modes (even for electronic
locking) and in the event of emergency. Pay careful attention to the messages in this manual
that are marked with the hazard symbol. They can either be warnings aimed at avoided
potential equipment damage or specific signals of potential hazard to the installer and others.
This device was designed to automate pedestrian swinging doors. Any other use is considered
contrary to the use foreseen by the manufacturer who therefore shall not be held liable.