Sesamo PROSWING R, Manual Instructions

Page: 20 / 48

20
SESAMO PROSWING
CL Fixed Door closed
CL Blinking Door closing
E1 Door needs self learning procedure (see Paragraph “Start up”)
E2
Wrong arm selection [DIP 1 or switch on break board - see Paragraph
“type arm selection”), or wrong selection automatism- DIP 5.
E3/E4 Over Current
E6 Error monitored sensors
E8 NO encoder
OPERATING LOGICS
LOGICA DESCRIZIONE
LOW-ENERGY
In all operative procedures (except Stop Close) it is possible a motor
opening with a reduced speed (Low Energy speed) and higher idle
time (idle time for disabled people) using the opening command for
disabled [AUX IN 1set through parameters 15=0 paragraph
“Parameter adjustment display”. The following closing is by spring.
PUSH & GO
An opening/closing automatic movement is possible slightly pushing
door in opening by hand while it is in a closed position. Set DIP 3 =
ON.
SAFE CLOSE
If closing safety sensor detects an obstacle whilst the door is closing,
it immediately stops and opens door completely .
If sensor detects while door is opening door continues opening.
SAFE OPEN
If opening safety sensor detects an obstacle whilst door is opening, it
immediately stops door movement. When detection stops, door
continues to open and then close.
If sensor detects while door is closing door continues closing.
If door opens toward a wall (in a corridor, for example) it is possible
to cancel the final part sensor detection to avoid wall detection. This
parameter is modifiable through parameter 20 (see paragraph
“Parameter adjustment display”).
Logic switch,
basic selector,
advanced
selector
operating logic
Manual
START 1 and START 2 are not working. Open and close only through
push button on selector or low energy or manually pushing the door.
1 radar
RADAR ONLY EXIT: Only START 2 input is working. A signal coming
from a sensor connected to START2 makes opening and closing of
the door. If the door is blocked by a lock or by motor (when no lock is
selected), the closing position depends on the type of lock or the
setting of parameter 14.
2 radar
RADAR ENTRY AND EXIT (Automatic): Both input START1 e START2
are working. A signal coming from a sensor connected to one of
these two inputs makes the opening and closing of the door. The
door blocked by lock or motor (when no lock is selected), the closing
position depends on the type of lock or the setting of parameter 14.
Stop
close
Automatism sends door in fully closed position. In this logic the
inputs START1 and START2 of the electronic control card are not
working; if installed, electric locking system locks door. When there