Sesamo PROSWING R, Manual Instructions

Page: 13 / 48

13
SESAMO PROSWING
5- Command lock release
This contact allows to unlock manually the
lock without opening door through motor.
6- Single command in
double system In case of Double system, opens only
MASTER
door.
7- Stand-by
When the contact is closed the door goes
in stand by status (unlocked and
deactivated) - this logics works with door
in closing.
8-Reactivation after stand-
by When the contact is closed the door start
working again after a stand by status.
9-Step/step function
An opening impulse will open the door.
Subsequent closing is possible with
another impulse.
* NO =Normaly open NC =normaly close
All INPUT mist refer to (COM)
Deafault setting. Can me modified (see
par.” Setting parameters- display”)
EXTERNAL PERIPHERICALS CONNECTORS
/
OUTPUT
SEGNALE DEFAULT
*
DESCRIZIONE
AUX OUT 1
AUX OUT 2
NO
Auxiliary output contact that can be set as follows:
0 - Monitoring sensors It monitors safety sensors.
1 - Inter lock
To be connected to the input interlock of
the other automatism, to obtain interlock
logic.
2 - Door opened It signals door in opened position.
3 - Door closed It signals door in closed position.
4 - Fault It signals door in fault.
5- Repeat lock command
it repeats the command of the electric
lock.
* NO =Normaly open NC =normaly close
All INPUT mist refer to (COM)
Deafault setting. Can me modified (see par.”Setting parameters - display”)
ATTENTION: to connect aux out contacts see electrical wiring as shown in Fig.22, Fig.23
e Fig. 26. Carico di max contact rating: 24V - 100mA
ATTENTION: Absorbing more than the max rating can damage control board.
INSTALLATION OF THE SENSORS
The automatism can work with:
- Safety sensors (vedi Fig.32 A e B): they are fixed on the door and detect the area in
front of them in order to avoid contact with persons/obstacles;
- Detection sensors (vedi Fig.32 C e D): generally fixed on the wall or wall frame,
detect the approach of peoples and give the input to open the door.