Sesamo PROSWING R, Manual Instructions

Page: 23 / 48

23
SESAMO PROSWING
2 with two Proswing installed on each door and connected together by a extension kit
Fig.30 (OPTIONAL).
The two Proswing, through a wiring on the selector terminal board, can exchange information
in order to rightly drive the two doors. It is needed to set one control door as a Master and
one as a Slave. The Slave acts only on Master command.
Per l’installazione del PROSWING Doppio con due Proswing singoli è necessario eseguire le
seguenti fasi:
1-
remove all components on both automatisms (in order : covers, end cap, control
boards, motor gears, transformers);
2-
fix the aluminum base of each single automatism on the relevant door following
instructions des cribed at paragraph “aluminum base holes positioning” – depending on the
type of arm used;
3-
connect together selectors terminal board in order to allow communication
between the two cards (Fig. 31)
4-
assemble again all the components taking care of disconnecting the selector switch
of slave door (see Fig. 1B)
For solution 2 with extra cover proceed as follows:
1-
remove all components on both automatisms (in order : covers, end cap, control
boards, motor gears, transformers);
2-
put the two aluminum base and the central joining base on a plane surface;
3- insert each base under the lug nut of the two joining parts as showed (Fig. 30);
ATTENTION: Maintain the orientation of the aluminum bases as shown in Fig 30, so that
the black end caps are positioned at the ends..
4-
tighten screws in order to obtain one single piece (Fig.30,Part. A);
5- fix the piece to the structure or wall following the instruction and positioning
dimensions described at the paragraph “aluminum base holes positioning” and paragraph of
the arm depending on the type used;
6-
connect together selectors terminal board in order to allow communication
between the two control boards.(Fig.31)
7-
reassemble all components of each proswing inserting to the extremity of the hinge
of the MASTER operator the end cap present in the KIT extra cover with the switch ON-OFF
and logic switch on the opposite side of the end cap , on the opposite end cap only the ON-
OFF switch.
ATTENTION: for both cases define, before making any connections, the door and the door
Slave Master.
Conventionally:
MASTER DOOR: is the first in opening and the last in closing (in case displacement)
SLAVE DOOR: is the second in opening and first in closing (in case displacement).
For both solutions, we must follow the following instructions to configure the electronic
boards:
1- To define Master and Slave use parameter 13: