Sesamo PROSWING R, Manual Instructions

Page: 6 / 48

6
SESAMO PROSWING
6)Do not install the product in explosive environment: the presence of flammable gases or
fumes is a serious safety hazard.
7)SESAMO is not responsible for the failure to comply with the Good Technical construction
procedure of the door to be automated, as well as deformations that may occur to the door
when using the same.
8)Before making any service to the product, switch off power supply.
9)Install a bi-polar switch to cut off power supply.
10)Verify functionality of ground wiring.
11)Safety devices (norm EN 12978) protect possible dangerous areas from mechanical risks
during movement, as. anti-crashing, conveying, shearing.
12)For maintenance use only genuine SESAMO spare parts.
13)Do not modify components that belongs to the whole automatism.
14)The installer must supply end user all the information in case of manual operating in
emergency.
15)End user shall refrain from any attempt to repair or direct intervention and ask only to
qualified personnel.
16) Installation must be done only from a qualified personnel and in full compliance with
regulations.
17) Everything not including in this operating instruction manual is not allowed.
18) This operating instructions manual is only intended for qualified personnel.
19) It is mandatory to use a MAG-LOCK to keep the door in closed position.
RECYCLING AND DISPOSAL
This product is built with different materials. The major parts (aluminum, plastic, iron, wires)
are solid urban waste. They can be recycled through collection and disposal in authorized
centers. Other components (control boards, etc.) may contain pollutants. They need to be
removed and hand over to companies authorized to recover and dispose them. The packaging
(paperboard, plastics etc.) are solid urban waste and they can be disposed of without any
problem, simply performing waste collection for recycling. Before proceeding it is always
recommended to verify local specific norm for disposal.
PLEASE RECYCLE!
INTENDED USE
IMPORTANT: PROSWING R must be used to automate pedestrian swinging door only.
This device is an electro mechanical system that allows to open and close a swinging door
using a transmission arm.
The door is moved by a movement open/close thanks to a spring/motor system or in opening
only with spring in case of NO power supply.
Programmable electronic control board allows correct functioning depending on the type of
installation.
It is alwasy necessary to combine a MAG-LOCK in order to keep the door in closed position.