Sesamo PROSWING R, Manual Instructions

Page: 15 / 48

15
SESAMO PROSWING
ATTENTION: LS must be repeated whenever the configurations of the sensors
connected or the automatism are modified.
ATTENTION: in case of double Proswing (2 wings) it is necessary to carry out LS
procedure on both control boards (master and slave).
Every time after power ON: initially is showed control board firmware version and later, for
two seconds, sensors configuration: S0 or S1 or S2 or S3.
In case sensor monitoring fails, the value of the relevant sensor blinks on the display (S1: safety
in opening; S2: safety in closing; S3: both). Blinking ends when monitoring is working again.
.
DIP
–
SWITCHES SETTING
On the control board there is a dip-switch 8 positions to adjust functionality and basic options
ON-OFF. These settings are set and memorized, duringt reset of the dip-switch during
operation they cannot be considered:
Changing of setting is considered only after automatism RESET
DIP PARAMETER OPTION DEFAULT
1
Arm selection
OFF Push arm
OFF
ON Pull arm
2
Mode
LOW ENERGY
OFF Normal
OFF
ON Low Energy
3
PUSH & GO
OFF Disabled
OFF
ON Enable
4 Key mode
OFF Bistable
OFF
ON Monostable
5 Tipologia Attuatore ON Proswing S ed R (Molla) ON
6
Inutilizzato OFF
7
Inutilizzato OFF
8
Inutilizzato OFF
P
ARAMETERS ADJUSTMENT
-
DISPLAY
It is possible to adjust several function parameters through two displays and relevant four
push buttons (Fig. 27).