Sesamo PROSWING R, Manual Instructions

Page: 24 / 48

24
SESAMO PROSWING
• MASTER (parameter 13 =1);
• SLAVE (parameter 13 =2);
Even in case of door without displacement it is necessary to set Master and Slave.
ATTENTION: use same power line for the two automatisms without any fuses or switches
between the two boards. Peripherals command (KEY, START 1 e START 2) have to be
connected to Master door. SAFE OPEN and SAFE CLOSE command have to be connected
separately on each control boards.
2- In case of door with overlapping it is necessary to set displacement movement. Usually in
opening a slight displacement is enough, but in closing, where it is important to be sure to
close on the right overlapping, an higher delay between the two doors is needed.
If there is no overlapping:
set on MASTER parameter 21 =0 and parameter 22 =0;
If there is overlapping:
set on MASTER parameter 21 and parameter 22 more than 0
3- To set in function automatisms follow Start up paragraph procedure, considering that LS
procedure has to be carried out on each control board separately and learning parameter LP
(point 6 and 7) has to be carried out only on MASTER door.
ATTENTION: when learning procedure starts it opens first MASTER door. It is necessary
to stop the door in the max opening desired point. Immediately after it starts opening the
SLAVE door and even for this door it is necessary to stop the door in the max opening desired
point. After this operation the doors will both start closing cycle (CL on display blinking). When
arrived in closed position CL stops blinking and door is ready to work.
Selector (optional) must be connected only on Master control board using the same terminal
boards to connect between each other the two operators. In case of changing parapeters
trough selector, they will be same for both control boards.
Closing cycle starts from the condition of doors fully in open position. In any condition one
door leaf will reach the full opening position before the other, it will wait until the second door
leaf will also reach the fully open position..
Inversion (START 1 o 2, SAFE CLOSE, anti-crashing) will happen simultaneously for both leaves.
Electric lock operation it is possible independently for each door.
Push & go: pushing one door will generate opening for both doors, does not matter which
one receive the push command.
Anti crushing and obstacles detections works independently on each control board.
Anti crushing in closing generates re-opening for both doors.
If one leaf detect an Anti Crashing in opening, it stops the movement of the door leaf, and
brings slowly to closed position. Second leaf, that meanwhile will have reached the completely
open position, will wait the second leaf before closing.