Section 4
Maintenance
Part Number 020003999 6/14
4-9
Front Serviceable
These instructions are provided as a guide for the
removal of the gear motor. Depending on the model
number of your dispenser, these instructions may vary
slightly.
1. Unplug the dispenser.
2. Unplug the motor.
3. Remove motor mount pins.
4. Slide motor towards you.
5. Notice alignment of the chamfered edge of drive
shaft. The new motor must have the same alignment
(within 15 degrees).
6. Get correct alignment one of two ways:
a. Turn drive shaft with an adjustable wrench,
being careful not to damage the drive shaft.
b. Plug in the unit, plug in the motor and use the
ice dispense switch to move the drive shaft into
correct alignment.
7. If the unit was plugged in to help with alignment of
drive shaft, now unplug the unit.
8. Slide motor up into housing, making sure that the
tabs fit on the bracket.
9. Install motor mount pins.
10. Plug in motor.
11. Test unit.
Summary of Contents for MDH-302 Series
Page 6: ...Table of Contents continued 4 Part Number 020003999 6 14...
Page 51: ......
