Section 4
Maintenance
Part Number 020003999 6/14
4-5
2. Remove the merchandiser. The merchandiser is
removed by taking out the two (2) screws located at
the top of the merchandiser. Once the screws are
removed, lift and rotate the top of the merchandiser
towards you and then remove the merchandiser
from the unit.
NOTE: When the merchandiser is removed, an electrical
safety switch kills power to the entire unit.
3. Remove rocking chute door.
4. Remove the decorative ice chute by pulling the
cotter pin out on the right side of the chute rod and
pulling the chute rod toward the left side of the
dispenser.
5. Remove the crusher drip pan by pulling up slightly
on the crusher assembly and pulling the drip pan
away from the foam front.
6. See the following steps to remove the ice crusher
blade assembly from the crusher housing.
A.
Unlock the crusher hub from the crusher
housing by pulling the locking tab out and
rotating the hub clockwise.
B.
Pull the hub and blade assembly out of the
housing approximately 1/2" (13 mm) to
disengage the crusher axle from the motor shaft.
C.
Rotate the knob on the crusher axle so it is in a
vertical position. (This will assure the rotating
blades will not interfere with pulling the blade
assembly from the housing.)
D.
Now the blade assembly will be free from the
housing. Completely remove the blade
assembly from unit.
GENII ICEPIC™ ONLY
COTTER PIN
CHUTE ROD
DECORATIVE
CHUTE
GENI
GENII
Cotter Pin
Chute Rod
Decorative Chute
SELECTABLE ICE
GENI, GENII & SCI drip
pans are the same. GENII
is illustrated on the left.
GENI, GENII & SCI
blade assemblies
are the same. GENII
is illustrated on the
left.
Summary of Contents for MDH-302 Series
Page 6: ...Table of Contents continued 4 Part Number 020003999 6 14...
Page 51: ......
