Operation
Section 3
3-4
Part Number 020003999 6/14
Component Identification
Sequence of Operation
ICE RECOMMENDED FOR DISPENSING
Dispensers are designed to dispense hard, cube ice up
to one-inch square. The ice shapes and sizes listed
above are recommended for dispensing. Warm “Super
Cooled” Ice Before Dispensing: “Super Cooled” ice is not
recommended for dispensing. “Super Cooled” ice is ice
that has been stored in freezers below 32°F. If it is
necessary to temporarily use “Super Cooled” ice, allow
the ice to warm at room temperature for 25 to 30
minutes before placing the ice in the dispenser.
NOTE: Manitowoc Half Dice Ice has been shown to give
the best performance in the icepic™ dispenser.
Hoshizaki America, Inc., ice machines with cresent-style
shape cubes are compatible with this dispenser but not
recommended.
NON-ADJUSTABLE AGITATION TIMER
The timer is non-adjustable and is set to agitate the ice
for 3 seconds every 3.5 hours. Activating the dispenser
will reset the timer. After 3.5 hours of non-use, the timer
will energize the dispenser motor.
The LED tells the technician in which mode the timer is
operating. Rather than a jumper pin, this timer has a
female spade connector that must be connected to
terminal number 6.
When this jumper is in place, the LED will blink at one
second intervals, this is the run mode.
When the jumper is open, the LED will flash every
0.4 second. This is the test mode and the timer will cycle
every 55 seconds in test mode. If the timer is left in test
mode, it will automatically reset to run mode.
Merchandiser
Nozzles
Key Switch
Drain Pan Grid
Drain Pan
Splash Panel
Nozzles
Ice Chute
(Crushed Ice on icepic™)
Nozzles
Selectable Ice on Units
with this Option
RECOMMENDED ICE
OTHER ICE SIZES AND SHAPES
Dice
7/8" x 7/8" x 7/8"
(2.2 x 2.2 x 2.2 cm)
Half Dice
3/8" x 1-1/8" x 7/8"
(1.0 x 2.9 x 2.2 cm)
Contour
3/8" x 1-1/4" x 1-1/4"
(1.0 x 3.2 x 3.2 cm)
Mini
7/8" Dia. x 3/4" Long
(2.2 cm Dia. x 1.9 cm Long)
Gourmet-Small
1" Dia. x 3/4"
(2.5 cm Dia. x 1.9 cm)
Crescent Cube
0.75"
(1.9 cm)
0.38"
(1.0 cm)
1.13"
(2.9 cm)
1
RED
NO
2
3
6
4
5
COM
NC
Summary of Contents for MDH-302 Series
Page 6: ...Table of Contents continued 4 Part Number 020003999 6 14...
Page 51: ......