Servend MDH-302 Series, Installation, Use & Care Manual

Page: 23 / 52

Section 2 Installation Instructions
Part Number 020003999 6/14
2-15
ADA KEY PADS
These instructions are for installations with this option.
1. Remove power from the unit.
Merchandiser Removal
2. Remove the medallion from merchandiser to gain
access to the area above the valve mount cap.
Medallions are removed through the top of standard
merchandisers and either side of the extended
merchandisers.
Splash Panel Removal
3. Remove the splash panel from the unit by removing
the two (2) Phillips head screws holding it in place.
ADA Wiring
NOTE: Follow these instructions for the right and left
sides of the unit.
4. Route the ADA ribbon cable under the drain pan.
5. Locate the ADA harness, units with a crusher it will
be on the left of the ice chute, non-crusher units will
be on the right. Continue routing the ADA cable
behind the valve mount cap up towards the ADA
harness.
6. Connect the ADA ribbon cable to the ADA wire
harness that is fastened to the foam front by a wire
clip.
7. Neatly tuck in and take up any slack remaining in the
ADA ribbon cable so it will not be in the way of any
moving parts or panels when they are placed back
on the unit.
Drain Pan & ADA Key Pad Box
8. Attach the drain pan to the unit.
9. Center the ADA Key Pad Box with the unit in front of
the drain pan and secure into place.
10. Apply corresponding drink labels to the ADA key
pads.
NOTE: If buttons are not used, they will be blanked out.
The Cubed/Crushed buttons are only utilized on units
configured with the Selectable Ice feature.
(
See ADA Key Pad Matrix Page 2-16 )
Drain Pan
ADA Ribbon
Cable
ADA Harness
ADA Box
Ribbon
Connector
Valve Mount
Cap
Important
If mounting the ADA Box directly in front of the drain
pan on the countertop, leave a minimum of 1"
(2.5 cm) space between the bottom edge of the
drain pan and the ADA Box to allow space for drain
pan removal.
ADA
Harness
ADA Wire
Harness Clip
ADA Box
Ribbon Cable
Connected
ADA Cables
Drain Pan
ADA Box ADA Box