Section 4
Maintenance
Part Number 020003999 6/14
4-3
Preventive Maintenance
Preventive maintenance is a vital part of keeping your
dispenser in top condition. Following the guidelines
below will assist you in continued trouble-free operation
of your unit.
1. Conduct daily maintenance of the machine.
2. Perform monthly maintenance of the machine.
3. Perform periodic maintenance and sanitizing of
beverage system.
4. Do not overfill the dispenser bin with ice.
5. Do not allow the dispenser to sit for prolonged
periods of non-use with ice in the bin.
6. Most ice dispenser service problems are caused by
low usage of the ice dispenser.
7. Do not allow ice to remain in the bin more than a day
in order to prevent ice from freezing together and/or
stagnant ice.
Possible excess ice storage reasons:
•
Storage capacity exceeds daily requirements.
•
Low demand during the off season.
•
Dispenser oversized with future growth in mind.
Lower ice storage to meet one day’s needs. If you
manually fill ice, fill only with the appropriate amount of
ice. Fill the dispenser with fresh ice each morning. Do
not fill the dispenser at night just before shut down. Ice
cubes can freeze together if not dispensed.
Disassembly
DISASSEMBLY FOR CLEANING AND
MAINTENANCE
NOTE: Sanitize the ice dispenser at Initial Start-up in
addition to monthly sanitizing. You will need a slotted
screwdriver in order to disassemble.
Disassemble parts in the following order:
A.
Merchandiser
B.
Ice chute
C.
Paddle wheel or agitator pins
D.
Agitator
E.
Paddle wheel
F.
Bin liner
G.
Paddle wheel area
Beverage/Ice Dispenser
Accessing a Dispenser Bin that is Top Mounted with a
Manitowoc Ice Machine:
1. Remove the front panel of the ice machine.
2. Remove the ice deflection baffle. This will give you
access to the dispenser bin.
3. If the Manitowoc ice machine is operating, wait for
the sheet of ice to fall into the dispenser bin.
Accessing a Dispenser Bin that is Top Mounted with a
Manitowoc Ice Machine and Large Extended
Merchandiser in front of the Ice Machine:
4. Access to the bin is possible through the strip lids on
the side of the dispenser.
Disassembling the Dispenser Parts for Bin Cleaning:
5. Remove the front panel of the Manitowoc ice
machine.
6. If the Manitowoc ice machine is operating, wait for
the sheet of ice to fall into the dispenser bin. When
the ice sheet falls into the dispenser bin,
immediately place toggle switch of the ice machine
to the OFF position. If the Manitowoc ice machine is
NOT operating, place the toggle switch of the ice
machine to the OFF position now.
Summary of Contents for MDH-302 Series
Page 6: ...Table of Contents continued 4 Part Number 020003999 6 14...
Page 51: ......
