Section 2
Installation Instructions
Part Number 020003999 6/14
2-13
CO
2
System
ROUTING INTERNAL CARB TANK PURGE TUBE
Some models are equipped with an internal carbonation
tank. These models require that the purge/pressure
relief tubing be routed to a drain.
1. Remove the splash panel.
2. Uncoil tubing and route between the front of the
dispenser and the drain pan.
3. Depending on drain location route the tubing
through the tubing bundle cutout or out the back of
the dispenser.
4. Verify the tubing is not kinked and then secure
tubing to maintain a minimum 1" (2.5 cm) air gap at
the drain. Follow any applicable local or national
codes.
DRAINS
Rear of Unit
A
To Drain
90° Elbow Fitting
Radiator Clamp
Flexible Tubing
Straight Fitting Radiator Clamp
Holes for beverage lines
Drainage Through Bottom
Drainage Through Back
Rear View
Radiator Clamp
Holes for drain pan drain
Flexible Tubing
Summary of Contents for MDH-302 Series
Page 6: ...Table of Contents continued 4 Part Number 020003999 6 14...
Page 51: ......
