Servend MDH-302 Series, Installation, Use & Care Manual

Page: 39 / 52

Section 4 Maintenance
Part Number 020003999 6/14
4-7
4. Rinse all of the parts with clean water.
5. Prepare 2 gallons of sanitizing solution by mixing a
1/2 ounce of household bleach (that contains 5.25%
sodium hypochlorite) with 2 gallons of 120°F (49°C)
water. The mixture should not exceed 100 PPM of
chlorine. Or mix a solution of any approved sanitizer,
following the directions for mixing and applying the
sanitizer.
6. Apply sanitizer to all parts with clean cloth, or by
spraying.
7. Allow to air dry. DO NOT RINSE.
8. Reassemble the ice crusher assembly by following
the instructions in the “Reassembling the Ice
Crusher Assembly” section.
9. Insert the blade assembly into crusher housing.
When inserting blade assembly, align the stationary
blades with the locating slots in the crusher housing.
10. When inserting the blade assembly into the crusher
housing, make sure the axle knob is in a vertical
position. This will align the rotating blades with the
housing to assure a quick and easy installation.
11. Once all blades are in the housing, align the crusher
axle with the motor shaft. Turn the axle knob and
push the blade assembly toward the motor until the
crusher hub is flush with the end of the housing.
12. To lock the blade assembly into the housing, rotate
the crusher hub counterclockwise until the locking
tab snaps into place and the crusher hub is secure.
13. Replace the crusher drip pan. Slide until it snaps into
place.
14. Reattach the decorative ice chute by inserting the
chute rod through the chute, housing mount and
motor mount. Secure the chute rod by inserting
cotter pin through the rod on the right side of the
housing mount. Make sure the arm of the
microswitch is in front of vertical protrusions on top
of the decorative chute.
15. Reinstall the rocking chute door.
16. Reinstall the merchandiser and secure with the two
screws that were removed during disassembly.
17. 110V power may be reapplied when the unit is
completely reassembled.
REASSEMBLE THE ICE CRUSHER ASSEMBLY
1. Insert the blade assembly into the crusher housing.
When inserting the blade assembly, align the
stationary blades with the locating slots in the
crusher housing.
2. When inserting the blade assembly into the crusher
housing, make sure the axle knob is in a vertical
position. This will align the rotating blades with the
housing to assure a quick and easy installation.
3. Once all blades are in the housing, align the crusher
axle with the motor shaft. Turn the axle knob and
push the blade assembly toward the motor until the
crusher hub is flush with the end of the housing.
4. To lock the blade assembly into the housing, rotate
the crusher hub counterclockwise until the locking
tab snaps into place and the crusher hub is secure.
5. Replace the crusher drip pan, sliding it until it snaps
into place by pulling up slightly on the crusher
assembly and pushing the drip pan toward the foam
front.
GENI, GENII & SCI
blade assemblies
are the same. GENII
is illustrated on the
left.
GENI, GENII & SCI drip
pans are the same.
GENII is illustrated on
the left.