Sensors & Software LMX200 Series, User Manual

Page: 59 / 133

Line Scan
59
orange section corresponds to the data shown on the left side. Pressing the left and right
arrows on the 4-way directional keypad will display different sections of the data collected; this
will also update which section you are viewing on the MapView display (Figure 6-9).
Figure 6-9: Collecting data in SplitView mode
In the LMX200, MapView will display all lines (collected with an external GPS) and grids
(collected with internal or external GPS) on the system.
In the LMX200 Enhanced, MapView will display all lines (collected with an external GPS) and
grids (collected with internal or external GPS) collected in a single project.
However, if lines/grids in a project (or any lines/grids in an LMX200) are collected far apart,
MapView will only display them if they are collected within a 2.5km radius of the currently
selected line. In this case, the data shown in the MapView display will follow the rules in the
order below:
•
Centre around the currently selected line or
•
Centre around the highest line number collected with GPS or
•
Centre around the highest grid number collected with GPS
If data exists outside the 2.5km radius, it will display the error message shown in Figure 6-10.