Senquip ORB-X1-G, User Manual

Page: 80 / 136

Warning text
Warning thresholds. Refer to user
guide.
input2.warning
Alarm text Alarm thresholds. Refer to user guide. input2.alarm
Alarm/Warning
Hysteresis
decimal
Once the input is in a certain state,
hysteresis is the amount by which the
input has to change before moving to
the other state.
input2.hysteresis
Output 1
Name text
A name for the input that is meaningful
to the user.
25 chars output1.name
Interval integer
Does not affect output mode. The
number of base intervals at which the
input is sampled. Set to 0 to disable. Set
to 1 for every base interval.
0 to
10000
output1.interval
Mode preset
Specifies the function of the OUT1
terminal.
output1.mode
Warnings boolean
Determines if the output is turned on
when a warning is active.
output1.warnings
Alarms boolean
Determines if the output is turned on
when an alarm is active.
output1.alarms
Alerts boolean
Determines if the output is turned on
when an alert is active.
output1.alerts
Hold Time integer
Sets the time in seconds for which the
output is held on after it is triggered. If
set to zero, the output remains on while
any exceptions are active.
Seconds output1.hold_time
Digital
Change Alert
boolean
If enabled, a change in digital state will
generate an alert.
output1.digital.alert.enable
Analog 3
Calibration
text
Calibration parameters for Analog 3.
Refer to user guide.
30 chars output1.cal
Unit text
The unit of measure associated with the
calibration.
Examples: Litres/min,
RPM, Volts
output1.unit
Warning text
Warning thresholds. Refer to user
guide.
output1.warning
Alarm text Alarm thresholds. Refer to user guide. output1.alarm
Alarm/Warning
Hysteresis
decimal
Once the input is in a certain state,
hysteresis is the amount by which the
input has to change before moving to
the other state.
output1.hysteresis
Thermocouple
1
Name text
A name for the input that is meaningful
to the user.
25 chars tc1.name
Interval integer
The number of base intervals after
which the thermocouple is measured
and events are checked. A value of 1
means that the input is collected every
base interval. Set to 0 to disable.
0 to
10000
tc1.interval
ORB User Guide, Release 1.1
74 Chapter 6. External Sensors