Senquip ORB-X1-G, User Manual

Page: 32 / 136

Note The LEDs turn on when the lid is opened because an internal sensor detects light. If the lid is
opened in dark conditions, the LEDs will not turn on.
Note After a firmware update, the LEDs may freeze or remain off for a few minutes. This is normal
behaviour and occurs shortly after firmware update when the ORB is encrypting the memory.
Factory Reset To perform a factory reset, press and hold the Setup button. While holding the Setup
button, press and release the Reset button. The green and orange LEDs will begin to flash fast. Continue
to hold the Setup button down for 10 seconds. After 10 seconds, the LEDs will stop flashing at which
point the Setup button can be released. All settings will be changed back to the factory state and the ORB
will restart. Any firmware updates made to the ORB will be preserved.
Warning Returning the ORB to factory defaults will remove all network settings, rendering remote
updates impossible.
Passwords The ORB is shipped, pre-loaded, with a random password that prevent unauthorised connec-
tion to the ORB’s Wi-Fi hotspot and prevent access to the ORB’s built in webserver. The default pass-
words are printed on a label that can be found under the ORB cover.
ORB User Guide, Release 1.1
26 Chapter 2. Getting Started