Using the EM 9046
66 |
Digital 9000
To synchronize the settings with your transmitters via infra-red:
왘
Select one of the channels 1–8.
왘
Switch on the transmitter to which you want to assign this channel.
왘
Press the
button
on the EM 9046.
The receiver switches to synchronization mode and the
LED
flashes.
왘
Place the transmitter’s infra-red interface in front of the infra-red
interface
of the receiver. Maintain a distance of approx. 10–20 cm
between the infra-red interfaces.
The transmitter and receiver are synchronized:
– After pressing the
button
, the receiver’s infra-red interface
searches for a suitable transmitter infra-red signal for 12 seconds.
– You can interrupt the synchronization at any time by pressing the
button
again.
– If a problem occurs during the synchronization process, read the
chapter “If a problem occurs ...” on page 95.
왘
Repeat the above steps for the remaining transmitters.