Using the EM 9046
64 |
Digital 9000
왘
Press the jog dial.
The infra-red interface
is activated and flashes blue, the “
Start
update
” menu entry is highlighted in blue:
왘
Place the infra-red interface of a transmitter in front of the infra-red
interface
of the EM 9046.
The currently installed firmware version of the transmitter and the
installable firmware are displayed.
왘
Press the jog dial.
First, the transmitter is read out and “
Scanning transmitter ...
” appears in
the menu selection of the receiver’s display panel. Then, the transmitter
firmware is updated: the infra-red interface flashes faster, “
Updating
transmitter ... (ca. xx s)
” appears in the menu selection of the receiver’s
display panel together with a time specification in seconds. Do not inter-
rupt the infra-red transmission during the update process.
To read out and, if necessary, update the firmware of additional transmitters:
왘
Place the infra-red interface of the transmitters in front of the infra-red
interface
of the EM 9046, one after the other, and proceed as
described above.
To return to the main menu:
왘
Press the
esc
button
During the update, the following icon appears on the display panel
of your transmitter:
If the firmware update was successful, this icon disappears and
“
Transmitter fw update successfull
” appears in the menu selection
of the receiver’s display panel.
If the update fails, the following icon appears on the display panel of
your transmitter:
In addition, the error message “
Error: Transmitter fw update failed
”
briefly appears in the menu selection of the receiver’s display panel.
In this case, place the infra-red interface of the transmitter in front
of the infra-red interface
of the EM 9046 and update the trans-
mitter firmware without interrupting the infra-red transmission.
Update to firmware:
Antenna booster
10-11-30-11
RF IN A:
Firmware:
AB9000_2
10-08-10-10
RF IN B:
Firmware:
AB9000_2
10-08-10-10
Start update
Transmitter
SCAN MODE
Transmitter:
Firmware:
...
...
New firmware ...