Sennheiser SKM 9000, Instruction Manual

Page: 45 / 109

44 | Digital 9000
Using the EM 9046 receiver
Switching the receiver on/off
To switch the receiver on:
왘
Make sure the ON / OFF switch
1
is set to position “ 1 ”.
왘
Press the standby button
3
.
The receiver’s operating system is loaded. During loading, the LED of the
standby button
3
flashes red and the display panel shows the
Sennheiser start screen.
Once the operating system is fully loaded, the receiver is in “
live ” oper-
ating mode.
To switch the receiver to standby mode:
왘
Keep the standby button
3
pressed for approx. 4 seconds until the
display panel goes completely off. The receiver is in standby mode.
To completely switch the receiver off and disconnect it from the mains:
왘
Set the ON / OFF switch
1
to position “ 0 ”.
All daisy chained signals are interrupted, i.e.:
– the antenna signals at the daisy chain outputs
E
and
H
,
– the booster supply voltage,
– the signal of the external word clock generator.
왘
Pull out the mains plug from the wall socket to completely disconnect
the receiver from the mains.
3