Senlan SB200 Series, User Manual

Page: 34 / 181

Inverter Operation and Trial Operation
30
When FC-00 is set up as 1 (user parameters are displayed only) or 2 (parameters other than factory
parameters are displayed only), the top hierarchy will not be displayed. This is intended to facilitate
user operations.
Password Verification
If a user password has been set up, enter the password verification status before entry into the
parameter editing status. In this case, “0.0.0.0.” will be displayed. The user may enter the password by
pressing , and (“ ―――― ” will be displayed when the password is
being entered). After the password entry is finished, press
确 认
E N T E R
to cancel password protection. If
the password is incorrect, the keyboard will flash and “ERR” will be displayed. Press
菜 单
M E N U
to
return to the verification state and press the same key again to exit from the verification state.
After password protection is cancelled, press
确 认
E N T E R
＋ under the monitoring status, or
avoid any key operation within 2 minutes, and password protection will be automatically actuated.
When FC-00 is set as 1 (only user parameters are displayed), the user parameters will not be subject to
password protection. But the user password is required when changing FC-00.
Fault Display
The inverter will enter the fault display status upon detecting a fault signal and the indicator lamp will
flash to display a fault code. The user may reset and rectify the fault by entering a reset command
(press on the control panel or operate via the control terminal or a communication command).
If the fault persists, the fault code will remain. The user may modify the incorrect parameters during
this time to eliminate the fault.
Alarm Display
If the inverter detects an alarm signal, the nixie tube will flash to display the alarm code. If more than
one type of alarm signal is emitted at one time, they will be displayed in an alternate way. Pressing
菜 单
M E N U
or to disable alarm display temporarily. The inverter will automatically detect the
alarm value. If the inverter returns to normal, the alarm signal will be automatically cleared. The
operation of the inverter will continue in the event of an alarm.
Other Display Statuses
Prompt Description
UP Uploading parameters
DN Downloading parameters
CP Comparing parameters
LD Resetting to factory settings