Seepex BW 10, Operating And Maintenance Instructions Manual

Page: 106 / 186

Holding Band
Re-assembly
Ausgabe
issue
B / 02.01.2006
Dokument
document
OM.HBD.01e
Blatt
sheet
2 (2)
•
Shearing off holding band (HBD) made of material
AISI 304 and AISI 316
A blow with the palm of the hand against the
cutting lever (SH) causes the end of the holding
band behind the loop (SCL) to be folded back and
sheared off. If the holding band on the sheared off
side is slightly raised as a result, it must be
straightened carefully.
CAUTION
Never tap or hammer against the loop of the
holding band (SCL), otherwise damage to the
universal joint sleeve may occur.
•
Shearing off holding band (HBD) made of
Hastelloy C
The high strength of this material makes it
impossible to shear off the holding band (HBD)
with the cutting lever (SH). Once the end of the
holding band is folded back, cut off the holding
band (HBD), file off projecting edges and remove
burr.
•
Check after mounting of holding band
The holding band must run all the way round the
groove of the universal joint sleeve.
The holding band (HBD) must be bent back and
sheared off at the holding band loop (SCL) in such a
way that the holding band (HBD) is unable to slip
back through the holding band loop (SCL). If this has
not been accomplished, then the holding band
(HBD) must be replaced by a new one.