18
ASSEMBLY
When the drive mechanism is disengaged, the belt
guides (item 4) must push enough on the belt (item 3)
so that the drive mechanism pulley does not turn.
Tighten the collar screw and the nut tightly.
WARNING
TO PREVENT INJURIES DO THIS VERIFICATION
WHEN THE ENGINE IS STOPPED.
NOTE:
After installation, attach the cable to the frame
with the new tie wrap supplied with this kit.
Drive mechanism disengaged
BELT ALIGNMENT VERIFICATION:
Make sure the drive mechanism pulley (item 1) is
aligned with the engine pulley (item 2) within 1/4"
If not, you may change the position of the support
(104344) and / or the position of the rear pins as
needed.
If the top edge of the belt touches the edge of the flat
pulley (item 3), remove the flat washer (item 4).
NOTE:Electric Clutch :
If your tractor is equipped with an electric clutch,
make sure the spring is well inserted in its place and
the belt does not touch the belt guides at any point.
NOTE: Manual Clutch:
If your tractor is equipped with a manual clutch, make
sure the belt guide does not touch the belt at any
point while the drive mechanism is engaged.
