16
TRACTOR WITH AN ELECTRIC CLUTCH.
No modifications are needed.
TRACTORS WITH A MANUAL CLUTCH
ACTIVATED BY A CABLE.
Remove the spring that is hooked in holes (item1) of
idler arm (item 2) and drive frame (item 10).
Hook the spring of the tractor’s cable (item 5) on the
tension arm.
Cut the tie wrap that holds the cable to the frame.
NOTE:
Depending on the mower deck model, there
are different cable lengths. To determine where to
place the cable holder (item 7), hook the end of the
cable spring (item 5) on the idler arm (item 2). Slide
the cable shield (item 6) temporarily into the slot on
the cable holder (item 7). To identify into which
holes the cable holder will be bolted in, you must
apply a slight tension on the cable. This adjustment
must be done with the clutch arm in the disengaged
position.
Remove the cable shield and secure the cable
holder (item 7) on the frame using two 1/4 x 3/4"
hex bolts (item 8) and flange nuts.
Reinstall the cable shield into the cable holder and
secure with a 2mm hair pin (item 9).
Install cable holder
ASSEMBLY
