17
4.2 Installation,
Set-up
and Training Requirements
Seal Graphics offers professional set-up, installation and training. It is
recommended that a certified engineer or electrician assist with
installation. Contact Customer Service to schedule.
The intended operator should be present during installation and training.
A licensed electrician must wire machine to the main electrical supply.
Power outlet close to the coater (within 5m).
Power cable (type HO7RN-F).
The electricity supply should have a “GFCI” protection device fitted. If in
doubt, please contact Technical Services or consult a local electrician
(see Section 3).
Compressed air supply, 100psi @ 3CFM (If No, fax customer services
on 800 257-7325 to order).
Adequate building sub-structure to support the weight of the machine,
supplies and operators.
Adequate space and ventilation.
Clean water source and drain (as close as possible to the intended
working area).
Check that all safety issues have been addressed (see Section 1).
The coater must be in final working position and all above installation
requirements met.
Sufficient substrate, for coating during installation & training (approx.
150ft or 50m).
Stock of AquaSEAL™ liquid laminate (If not, fax customer services on 1-
800-257-7325 to order).
Summary of Contents for AquaSEAL SW-2600
Page 4: ......
Page 43: ...Notes 31 33 ...
