NOTE:
It is strongly recommended that the unit is fed from an GFCI – if in
doubt, please contact Seal Graphics Technical Services (listed at rear of
manual) or consult a licensed electrician.
1.4 Mechanical
Avoid reaching in or around the pinch points and hot spots when the
unit is running (see Section 1.7).
Operating the unit outside the operational instructions of this manual
may result in injury, damage to the unit, and/or voiding the warranty.
1.5 Chemical
When handling any chemical products, read the manufacturers’
container labels and the Material Safety Data Sheets (MSDS) for
important health, safety, and environmental information.
To obtain MSDS Sheets for AquaSEAL™ Products, please call your
local distributor.
CAUTION:
ALWAYS OBSERVE MANUFACTURERS’
RECOMMENDATIONS WHEN HANDLING CHEMICALS.
1.6 Pneumatics
There can be up to 125psi (pounds per square inch) of air
compression in the unit at any one time. A visual check of the system
before start-up is recommended. A periodical check of the system’s
integrity is required.
The maximum air compression is 125psi; the recommended is 90-
100psi
@
3cfm.
2
Summary of Contents for AquaSEAL SW-2600
Page 4: ......
Page 43: ...Notes 31 33 ...
