2.9 AccuCure IR Heat Sensor
The AccuCure IR Heat Sensor is located on the
slide rail mounted to the back of the Dryer
Panel. The sensor reads the surface
temperature of the substrate as it leaves the
Dryer Panel. The temperature readings can be
viewed on the main operating screen of the
Control Panel.
NOTE:
The location of the AccuCure IR Heat Sensor can be
adjusted different substrate sizes, within up to 12” of either side.
Figure 8: AccuCure IR
Heat Sensor
2.10 Photo Eyes
The coater has three (3) sets of Photo Eyes: the Draw-Down
Applicator set is at the front of the coater, and the other two sets of
photo eyes are in front and behind the Dryer Panel.
Both the Draw-Down Applicator and Dryer Panel operate using
pneumatic cylinders that lift up to web the machine and draw down to
run substrate. The Photo Eyes are a safety feature that will raise the
assemblies when the beam is crossed.
The Photo Eyes are active for 5 seconds upon initiation of lowering
the Draw-Down Applicator and/or Dryer Panel. Once these
assemblies are lowered into position, the safety hazard is removed
and the Photo Eyes become inactive during operation of the coater.
If a Photo Eye is blocked while the Dryer Panel
is lowering, the Dryer Panel Switch must be
reset to the UP position and then back to
DOWN position to lower the Dryer Panel again.
2.11 Sealant Distribution Valves
Figure 9: Sealant
Distribution Valves
The Sealant Distribution Valves control the
distribution of coating across the substrate as it
passes underneath.
2.12 Sealant Drain Pan
The Sealant Drain Pan takes over-flow sealant and drains it into the Sealant
Tanks.
10
9
Summary of Contents for AquaSEAL SW-2600
Page 4: ......
Page 43: ...Notes 31 33 ...
