2.21
Speed Control Display
The Speed Control Display is a touch-screen display, and is used to set
the controlling parameters of the AccuCure Feedback System.
14
Set-Up Screen
The Set-Up Screen will display when the coater is turned ON. This
screen allows the user to select units, English or Metric. Once units are
selected, the Main Screen will be displayed.
Main Screen
The PREHEAT, RUN and HEAT ON/OFF are status displays and will
light when a process is active.
The SPEED Mode and TEMP Mode are functioning buttons that, when
touched, will activate another control screen.
Speed Mode Screen
The Speed Mode Screen controls starting or stopping the substrate
DRIVE. To start the DRIVE, touch the RUN DRIVE button.
To stop the DRIVE, touch the STOP DRIVE button.
In addition, the desired speed of the substrate running through the
coater can be set on this screen. The FPM/MPM
(ft/min or meter/min)
speed is set with the up/down arrows at this menu. The top speed
displayed is the actual speed, and the bottom speed displayed is the
selectable speed.
Temp Mode Screen
On the Temp Mode Screen you can set the desired temperature for the
top of the substrate as it exits underneath the Dryer Panel (as
measured by the IR sensor). To set the temperature, touch the Temp
read out and a keyboard will appear, enter the temperature and touch
the enter key.
13
Summary of Contents for AquaSEAL SW-2600
Page 4: ......
Page 43: ...Notes 31 33 ...
